bucket elevator

bucket elevator

  1. The cause of this might be base plate and chain bucket of bucket elevator collide with each other. To fix this is to adjust the take-up device of base in order to stretch the chain.
  2. Another reason is the driving shaft and driven shaft key is flabby, the sprocket is drift, chain bucket collides with casing. To fix this we can adjust the position of sprocket needs to be adjusted and the key needs to be stretched.
  3. Another common reason is that the guide plate collides with chain bucket. It can be fixed by readjusting the position of guide plate.
  4. Next reason being there are some materials mingled in the guide plate and chain bucket which can be fixed by enlarging the inputs angle of material inside the base.
  5. Other than that the noise can be created by the failure bearing causes inflexible operation of bucket elevator machine which can be fixed by the replacement of bearing.
  6. Also, the pieces of materials or other objects stuck in the casing can cause abnormal noise. To fix this, we stop the operation of bucket elevator and remove the materials.
  7. The gear profile of sprocket (driving and driven sprocket) which abnormal could also be the cause. Correct the gear profile of sprocket should be used.
  8. When the gear profile of driving sprocket and chain is out of order it also can cause abnormal noise where it can be fixed by the adjustment of sprocket gear profile.
  9. Also it can be caused by drive chain idling but this can be corrected by adjusting the length of the chain.
  10. Lastly is the casing is not installed properly where the full length of vertical alignment of casing needs to be adjusted.

Above is the reasons for unwanted noise during the operation of bucket conveyor, want to learn more, welcome to visit our website: www.pkbucketelevator.com

发表评论

电子邮件地址不会被公开。 必填项已用*标注